Sansui AU-x19 integrated amplifiers · c. 1978–1981

The AU-919 topped Sansui’s AU-x19 range, an integrated of about 47 lb with a built-in moving-coil phono stage. It arrived around 1978 and sold into the early 1980s. Sansui’s 1979 US ads rated it at 110 W per channel into 8 Ω from 5 Hz to 20 kHz at no more than 0.008% THD. They also pushed its Diamond Differential DC (DD/DC) circuit, used in both the power amp and the phono equalizer, as a way to lower transient intermodulation distortion as well as THD. The power amp is direct-coupled, with a claimed response from DC to 500 kHz. Inside are two power transformers, an EI-core unit for the preamp and pre-driver stages and a large toroid for the driver and output stages, plus four 15,000 µF filter capacitors and several separate regulated supplies. Phono 1 takes moving-coil as well as moving-magnet cartridges, and the tone controls have switchable turnover points and a defeat switch. It’s a complex amp, so pay for a service done from the manual.
The AU-919 has many internal adjustments, including DC servo and offset trims, so a recap without recalibration can leave it misbehaving. Sansui’s hardened glue from this era can turn corrosive and attack component leads. The moving-coil stage has its own adjustments, and faults there are easy to miss.
No AU-919 is for sale on eBay right now. This week's search found only a 1978 magazine test report and a protection relay, so we can't give a fair price range yet.
Nothing was listed for the Sansui AU-919 Integrated Amplifier when we checked.
This model comes and goes. The live search below shows anything listed since Oct 19, 2026.
Prices change daily. The live eBay search shows everything listed now, including anything new since Oct 19, 2026.
See every listing on eBay →Noisy volume and tone controls and crackly selector switches are the usual first job on a used AU-919. Contact cleaner fixes most of it. Leave bias and offset adjustments to the service manual or a technician.