Kenwood KA-x100 integrated amplifiers (late 1970s) · c. 1977–1979
Kenwood built the KA-9100 around its power supply, giving each channel and the preamp a supply of its own. Those three separate supplies extend the dual-supply approach of the KR-x600 receivers. Kenwood billed it as a “DC Stereo Integrated Amplifier” in the late 1970s and placed it above the KA-8100, rated at 90 watts per channel into 8 Ω, 20 Hz–20 kHz, at 0.03% THD. It also quoted 95 W per channel at 1 kHz, 110 W into 4 Ω, and response extending down to DC. The power amp is DC-coupled with no input capacitors. There are two phono inputs, two power meters with a compressed log scale, Baxandall tone controls, subsonic and high filters, two-deck tape dubbing, and pre/main connections for using the sections on their own. It weighs about 37 lb. It was built to a higher standard than most mid-priced integrated amps of its time, which suits it to a separates system.
Without its pre-out/main-in jumpers the amp plays nothing. Because it’s direct-coupled, drifting DC offset can thump or damage woofers. The volume, balance and tone controls and the selectors are where crackle shows up.
Nothing complete is for sale right now. Our last band, $260–270 delivered, came from a single wood-cased unit with no condition given, so treat it as a rough guide. When one shows up, ask for a DC offset reading and look at the back panel photos for the pre-out/main-in jumpers.
Nothing was listed for the Kenwood KA-9100 Integrated Amplifier when we checked.
This model comes and goes. The live search below shows anything listed since Oct 3, 2026.
Prices change daily. The live eBay search shows everything listed now, including anything new since Oct 3, 2026.
See every listing on eBay →Noisy volume and tone controls and crackly selector switches are the usual first job on a used KA-9100. Contact cleaner fixes most of it. Leave bias and offset adjustments to the service manual or a technician.